Wet-into-wet techniques
There's no experience more exhilarating than dropping rich colour on
to wet paper and watching things happen. However wet-into-wet is a bit
of a misnomer because if you do actually drop wet paint on to a wet
surface you then get two lots of water and the result is weak, runny and
out of control.
If the paper is already wet you can use the paint thick, almost
straight from the tube. It will mix with the water on the paper and
soften but will stay rich and controllable.
Gaining experience
Apart from describing the main pitfalls, there is no way I can really
explain the technique. You just have to experience it and experiment
yourself. First, try it out with one colour for in start with Burnt
Umber, and let yourself go fearlessly don't be timid.
Always have the painting on a gentle slope and use gravity to help
you, which can be rather like swimming with the current. It is so much
less effort and you will need less strokes.
The technique is ideal for doing cloudy skies mists, billowy trees,
and surging surf, but remember not to do the whole painting in
wet-in-wet, it will just look out of focus. A word of warning, never use
wet-into-wet for foregrounds, they, at least should be crisp and sharp,
otherwise it will look as if you're wearing the wrong glasses. The most
flashiest technique in painting is that of flowing rich colours on to
wet surface and watching the resulting mixtures flows and blend. Control
of wet techniques takes much practice and experience and the rewards are
often quite exhilarating. With experience you will gain confidence and
find yourself painting complementary colours under every wash.
Experience will teach you the necessity of speed and the correct mixture
of water and pigment.
Succeeding steps
A good example of the use of wet-into-wet, reproduced in the painting
I have done here titled 'gem minining at Ratnapura' shows the strong
paint used to get the dark trees at the background, whilst the distant
hill was still damp. The sky and the mountains done with ultramarine
blue creating balance without boredom. Note the trees in dark colour
provide a link between the blues of the sky and the green of the
landscape.
The focal point (the gempits) is shown with miners working while the
river curves in on the right. To get a balance composition a hut is
drawn on the left corner with a minor wash is applied while the initial
wash is still wet.
The entire painting was done using complementary glazes of
wet-into-wet.
Slurpy skies, large soft surface, billow trees and surging surfs can
be flowed on to wet sheet with a loaded brush. When running colours on
to a saturated paper, be sure they are quite intense since they will dry
lighter.
Remember that the water in the paper dilutes the colour as it flows
from the brush, so the fresh colour needs to be put on relatively dry if
to stay in place. You cannot explain verbally now it is - the process
must be experienced.
The wet paper is usually worked on white flat, because a slanted
surface will cause colours to run toward the bottom of the sheet. Rough
or textured papers generally work better than smooth. Combination of
paper wetness and intensity of colour vary from minute to minute.
A brush with very thick paint can make a fairly sharp line even on a
wet sheet. Experiment with several drawing sheets to determine the best
times to get the best effects.
Most artists apply the lightest areas down first, darkening the
colours. As with dry brush techniques, not many paintings are made only
with wet-in-wet techniques. The method produces best results when the
exquisitely soft edges are contrasted with some sharp-edged areas
applied to the painting when it is dry or almost dry.
Try some experiment studies on a variety of papers that have been
soaked various lengths of time.
Many conditions such as temperature, humidity and air movements will
change the results, but some important generalities can be learned that
will apply to most cases. Enjoy the happy accidents that occur and keep
them in mind for possible later use.
www.tissahewavitarane.com
|